AUTOSPARK. Maybe one of the sensors is faulty. Switch the ignition on, select reverse gear, then go to the back of the car and lightly rub a finger back & forth over the face of each sensor. You should be able to feel them pulsing. The one that isn't is the one that is faulty. A proximity sensor used in the park assist system. Why Buy: A malfunctioning backup warning sensor can cause your parking system signal not to sound at all or sound at inappropriate times. If your Ford is experiencing problems like these, our technicians can help. Reflect on the best position of the sensors to avoid blind spots, using the supplied drill bell, drill your bumper. Position your various sensors. Route the cables to the headlamp unit that includes your reverse light. Get the current from the wires to connect your parking sensors to this one. Give it a try all out.

Hi all! So I have a 2015 Ranger Wildtrak, and has an annoying problem. I bought it 2nd hand (from a dealer who was $*1T), since I’ve had it the reverse sensors don’t work. A friend who is a mechanic had a look and suggested after checking the wires that it must be disconnected from the module, a quick look online and bingo it’s under the

Remove the bumper if you don’t have access to the inside of it. Think about the ideal location of the sensors to avoid blind spots, using the supplied drill bell, drill your bumper. Position your various sensors. Route the cables to the headlamp unit that contains your reverse light. Get the current from the wires to connect your parking Hi thanks for the reply. I swapped the faulty sensor with each of the 3 nearside ones and always got the same fault (offside) all the nearside worked ok each time. I'm thinking either the module or a break / short in the wiring is the issue. I can get access to a 2001 S500 module if I need it to rule that out firs befor tackling the wiring. xH5Ca. 667 745 869 520 591 67 929 39

ford c max parking sensor module location